Stonewashed Titanium Peanut

The Peanut features a rear switch design and uses the Quantum Dragon driver, which offers programable secondary RGB leds, power levels, memory and a triple tap strobe. Also included is thermal regulation and voltage protection The Peanut is powered by an 18350 flat top battery, incorporates all electronics on one board which saves legnth on the light . The dimensions are .99" diameter and 2.85" legnth. THIS IS FOR A STONEWASHED PEANUT SHIP TIMES VARY DUE TO HIGH DEMAND AND AVERAGE 5-7 DAYS PROGRAMMING Quantum DragonMode Groups* Group 1: Color, ML, 5%, 15%, 35%, 50%, 100%* Group 2: Color, ML, 35%, 100%* Group 3: ML, 5%, 15%, 35%, 50%, 100%* Group 4: ML, 5%, 15%, 100%* Group 5: ML, 15%, 100%* Group 6: 5%, 15%, 35%, 50%, 100%* Group 7: 15%, 100%* Group 8: 15% - 50%* Group 9: 100% Only* Group 10: Color, 100%* Group 11: 100%, Color* Group 12: Color, 50%* Group 13: 50%, ColorConfiguration Options:To enter configuration mode, quickly cycle the switch 12+ times until it starts to flash. Once it starts to flash,you are in configuration mode. Once in configuration mode, the light will give a solid light and ramp down, if youwant to modify options 2-4 cycle switch during ramp to move to next option.* Option 1 = Mode group, when light ramps down it will flash all 3 colors and then the group number in white lightfollowed by all 3 colors. To select the group flashed in white light cycle the switch in the next color cycleafter the group number you want to use is blinked out.* Option 2 = Secondary color choice, when light ramps down it will blink twice to show its in the second optionand flash each color several times, cycle switch while the color you want to use is flashing.* Option 3 = Memory on/off, when light ramps down it will blink three times to show you its in the third optionand flash red or green several times. Cycle the switch while flashing red if you want memory off and green if youwant memory on.* Option 4 = Strobe option, when light ramps down it will blink four times to show its in the fourth option andflash each color several times, cycle switch while flashing red for off, green if you want standard strobe andblue for bicycle mode. To access these in normal use cycle switch rapidly three times and it will access eitherstrobe programmed when turned on.